>>Racing Optics Windshield Stack™
Install Instructions
Installation Tools and Supplies Needed:
- 8”
Cleaner Squeegee
- 5-1/2”
Power Squeegee
- White
Teflon Hard Card
- Plastic
Utility Knife or Razorblade
-
Bounty® Paper Towels (or equivalent)
- Spray
Bottle and Nozzle
Installation Steps
NOTE: READ ALL INSTRUCTIONS BEFORE STARTING. Cleanliness is very
important: Any dirt, dust, paint, or stickers should be removed
from surface before application. Impurities will show as a small
bubble or spot when the tearoff adhesive has cured. When trimming
on Lexan, mark the tearoff and trim on a separate surface using
a razor blade or scissors.
- Place the tearoff on the windshield to determine
proper sizing. Mark and trim if necessary. Note: The tearoff has
a clear backing with the words “This Side Down-Remove and
Discard” this label should be facing the windshield.
- Clean the windshield with application solution
and the 8” cleaning squeegee, using horizontal overlapping
strokes, starting at the center top and working down.
- Wet the windshield with the application solution
provided.
- Remove the clear backing from the tearoff and
spray the adhesive side of the film with the application solution
leaving no dry spots. Position the tearoff on the windshield.
- Wet the tearoff, then tack it using the 8”
cleaning squeegee as shown in the diagram below. Carefully work
the air bubbles toward the edges.
- Start in the middle, working down, and then
up. Then use overlapping horizontal strokes, working any larger
air pockets toward the edges
- F. Wet the tearoff again, then power squeegee
with the 5-1/2” power squeegee using overlapping strokes,
as shown in the diagram above.
-
Repeat previous step ensuring all excess solution has been removed.
- Press out all edges using the white Teflon hard
card wrapped in a Bounty® Paper Towel.
|
|
